1 How to wire the car terminal welding

Before using wiring terminals, obtain the following documents: wiring terminals, screwdrivers, and cables.

First, peel the insulation skin of the wire 6-8 mm.

Second, then insert the exposed wire into the inside of the terminal.

Third, then use a screwdriver to tighten the top screw.

4. Pull it with your hand to make sure it doesn't fall.

Five, then press the switch, see the point light, so that the wiring terminal is completed.

2. Terminal usage diagram

Wiring terminals suitable for a large number of wire interconnection, in the power industry has a special terminal block, terminal box, above are all wiring terminals, single, double, current, voltage, ordinary, broken and so on. A certain crimping area is to ensure strong contact and to ensure that sufficient current can be passed.

The terminal is used to facilitate the connection of the wire, which is actually a piece of metal sealed in insulating plastic, with holes at both ends to insert the wire, and screws for tightening or loosening.

Today's terminal applies the existing rail terminal frame screw connection technology, and installs the circuit composed of electronic components to complete the transmission coupling of the photoelectric process.

The center of automatic control is that the control unit must be firmly separated from the sensors and actuators, so as not to interfere, Sanmenwan WUKG2 optical insulation terminals can complete this function well, and ensure that the field signal matches the low voltage requested by the electronic control installation, and can also be used as the interface element between the peripheral equipment of process control and the control, signal and the regulator installation. And suitable for different voltage and power range.

Terminal has the advantages of control end signal loss, high switching frequency, no mechanical contact flutter, no wear switching, high insulation voltage, not afraid of vibration, not affected by position and long life, so it is widely used in the field of automatic control.